Are your Gas Line Repair services available in Clovis?

Yes, Masters Plumbing Service provides round-the-clock Gas Line Repair services directly in Clovis, NM.

How much does emergency service cost in Clovis?

We offer upfront, transparent pricing with no hidden fees for all service calls in Clovis.

🔬 Combustible Gas Detection · Manometer Pressure Testing

Professional Gas Line Repair in Clovis, NM — Leak Found, Repaired, Pressure-Tested

Name: Masters Plumbing Service
Telephone: +1-855-718-1500
Price range: $$
Rating: 4.9

Gas line work belongs in a narrow category of plumbing tasks where there is no acceptable shortcut. A fitting that isn't fully threaded, a connector that was bent during installation, or a repair that skips the post-work manometer pressure test can produce a leak that's invisible and odorless until conditions for ignition are met. Masters Plumbing Service's certified gas plumbers in Clovis, NM use combustible gas detectors at every connection point after every repair — and every job ends with a documented manometer pressure test before gas is restored to any line we've worked on.

📞 Call +1-855-718-1500 — Certified Gas Plumbers

Certified Gas Plumbers in NM Combustible Gas Detector Manometer Pressure Test Standard Permit & Inspection Handled

Licensed Gas Line Repair service in Clovis, NM - Masters Plumbing Service

Our Gas Line Standards

What Separates Certified Gas Work from Unqualified Shortcuts

These aren't marketing points — they're the minimum requirements for safe gas line work. Every Masters Plumbing Service gas job in Clovis, NM meets all four, on every call, without exception.

📜

NM-Certified Gas Plumbers Only

Gas plumbing in NM requires specific certifications beyond a standard plumbing license. Every technician we dispatch for gas work holds an active state certification for gas line installation and repair. We can provide license numbers and certification documentation before any work begins — and we encourage you to verify them with the NM licensing board.

🔬

Combustible Gas Detection at Every Connection

After any gas line repair, installation, or reconnection, we pass a calibrated combustible gas detector — sensitive to natural gas and propane at concentrations far below the lower explosive limit — over every fitting, joint, and appliance connection we worked on. A clean detector pass at every point is required before the job is closed out.

📊

Manometer Pressure Test — Always

A manometer measures gas line pressure precisely over a timed hold period. After any repair or new installation, we isolate the segment, pressurize to test pressure, connect the manometer, and hold for the required duration. Zero pressure drop confirms a leak-free installation. We document the test result — pressure, hold time, and pass/fail — and provide you with a copy.

🏛️

Permits Pulled, Inspections Scheduled

A permit isn't just a bureaucratic step — it's an independent safety check. The inspector confirms our work meets the applicable code. That second set of eyes protects you, and we welcome it.

Our Gas Line Services

Every Gas Line Repair Service We Provide in Clovis, NM

Every job follows the same detection and pressure-testing standard regardless of scope.

Emergency

Gas Leak Detection & Repair

If you smell gas — the distinctive sulfur/rotten-egg odor added to natural gas for detection — the immediate protocol is: leave the building without operating any switches, leave the door open, call your gas utility's emergency line from outside to shut off the street supply, then call us. Our certified gas plumbers arrive with combustible gas detectors to locate the exact source of the leak in service lines, appliance connectors, meter risers, or distribution piping inside the structure.

Appliances

Gas Appliance Connection & Reconnection

Flexible corrugated stainless steel tubing (CSST) connections require proper bonding in most NM jurisdictions to prevent damage from nearby lightning events — a code requirement many contractors overlook. Our gas techs are CSST-bonding trained.

New Runs

New Gas Line Installation

Adding a gas barbecue outlet, running gas to a new range or cooktop, extending gas to an outdoor kitchen or pool heater, or adding a gas stub for a whole-house generator — all require a new gas line run sized correctly for the BTU demand of the connected appliances and the existing line's supply pressure.

Pressure Test

Gas System Pressure Testing

A standalone gas system pressure test — without any repair or installation — is requested for several reasons: before purchasing a home with gas appliances, when an unexplained gas smell has been investigated and not found but a homeowner wants confirmation the system is sound, or at a contractor's request before final inspection.

CSST

CSST Flexible Gas Piping Service

Corrugated stainless steel tubing (CSST) is the flexible gas piping used in most newer Clovis homes — it's faster to install than rigid black iron and routes easily through framing. However, CSST requires specific installation requirements: proper fittings, correct bonding to the electrical grounding system, and protection at penetration points to prevent abrasion damage.

Propane

Propane System Service & Repair

{Propane systems used in areas of Clovis, NM without natural gas service have specific considerations compared to natural gas: different line pressures at the regulator (propane distribution pressure varies by system design), different BTU content per cubic foot, and propane's behavior of settling low (it's heavier than air, so propane accumulates at floor level rather than rising to ceilings).|We service propane supply lines from the tank to the structure, appliance connections, regulator function checks, and leak detection using detectors calibrated for propane's lower explosive limit.}

📞 Call +1-855-718-1500 — Certified Gas Plumbers Ready

Our Process

Our Gas Line Safety Protocol in Clovis

Every step exists because gas work without it is unsafe, regardless of how minor the job appears.

Call & Emergency Protocol If Active Leak

Active gas smell: stay out of the building, call your utility to shut street supply, then call us. Non-emergency gas work (new runs, appliance connections, pressure testing): call to schedule — we confirm certification documentation and permit requirements for your specific job scope before arrival.

Gas Detection Survey & System Assessment

On arrival, we conduct a detector survey of the full accessible gas system — not just the suspected area. This establishes a baseline and catches any pre-existing issues beyond the immediate call scope.

Flat-Rate Quote, Permit Coordination, Work Execution

For leak repairs, the gas remains off on the affected line until the repair is complete, the detector passes every joint, and the manometer test confirms a leak-free system.

Manometer Test, Detector Survey, & Written Documentation

After every gas job — repair, new run, or appliance connection — we conduct a timed manometer pressure hold test on the affected segment and detector-test every connection point. You receive the written test result as part of your job documentation.

Customer Reviews

What Clovis, NM Property Owners Say About Our Gas Work

★★★★★

Needed a new gas line run to an outdoor kitchen setup. Masters Plumbing Service sized the line correctly for the combined BTU load of the burners and the side burner, ran 3/4-inch black iron through the crawl space and up through the exterior wall, installed a shutoff at the outlet, pressure tested the new segment, and handled the permit and inspection scheduling. Inspection passed first time.

— M. Rashid, Clovis

★★★★★

Had three contractors look at moving a gas range — two said they couldn't do it because of the CSST in the line. Masters Plumbing Service's tech was CSST-qualified, relocated the range connection with the correct CSST fittings, added the required bonding conductor to the grounding system, and pressure tested the modified segment. Permit closed with no issues. Very professional from start to finish.

— S. & A. Ibrahim, Clovis, NM

★★★★★

Called Masters Plumbing Service for a propane system inspection before buying a rural property. Their tech checked the regulator function, distribution line pressure, tank connection, and all appliance flex connectors. Found one connector that was beyond its rated service life and replaced it. Written pressure test documentation and a clear condition report on the full propane system.

— T. Andersen, Clovis, NM

Trusted Gas Line Repair service in Clovis, NM - Masters Plumbing Service

Common Questions

What to Know Before Scheduling Gas Line Repair in Clovis, NM

Do not re-enter the structure to search for the leak source yourself. Do not use soapy water to check fittings while gas may still be present in the structure. Our certified gas techs with proper detection equipment handle the leak location and repair safely.

A manometer is a precision pressure gauge — either liquid-column or digital — that measures gas line pressure to a fraction of an inch of water column. After any gas line work, we isolate the repaired segment, pressurize it to the required test pressure, connect the manometer, and hold for a timed period. Any pressure drop during the hold period indicates a leak somewhere in the tested segment.

We strongly advise confirming certification before allowing any contractor to work on your gas system. An unlicensed repair that causes a subsequent leak or fire creates complex insurance and liability issues in addition to the obvious safety risk.

Corrugated stainless steel tubing (CSST) is a flexible yellow or black jacketed gas pipe used in most homes built or remodeled after approximately 1990. It's safe when installed correctly and properly bonded to the electrical grounding system. Early CSST installations — particularly from the 1990s through the mid-2000s — often lacked the bonding conductors now required by most codes following research showing ungrounded CSST can be damaged by nearby lightning strikes.

The inspection is an independent confirmation that the work meets code — including pressure test documentation, pipe sizing, and appliance connector ratings. We provide the inspection record as part of your job documentation.

Yes — this is one of the most common new gas line requests we handle in Clovis, NM. We calculate the BTU demand for all connected appliances in the new run, size the supply pipe to deliver adequate pressure at full combined load, run the line at required burial depth for the exterior portion, install a properly rated outdoor shutoff valve, and pressure test the new segment before any appliances are connected.

Professional Gas Line Repair in Clovis, NM — Leak Found, Repaired, Pressure-Tested